Fuji Xerox ApeosPort-IV C5580, ApeosPort-IV C6680, ApeosPort-IV C7780, DocuCentre-IV C5580, DocuCentre-IV C6680, DocuCentre-IV C7780 Administrator Guide

Emptying the Punch Scrap Container for Finisher D2 P with Booklet Maker

Emptying the Punch Scrap Container for Finisher D2 P with Booklet Maker

Replacing Consumables
89
M
a
i
n
te
na
nc
e
3
2
Pull out the punch scrap container R4 
towards you.
3
Discard all the scraps.
4
Insert the empty punch scrap container into 
its original position until it comes to a stop.
5
Close the front cover of the finisher.
Note
• A message will be displayed and the machine will not operate if the front cover of the finisher 
is even slightly open.
Emptying the Punch Scrap Container for Finisher D2-P with Booklet 
Maker
When the Finisher D2-P with Booklet Maker (optional) is installed and the punch scrap 
container becomes full, a message appears on the touch screen. Discard the scraps 
according to the message.
If you take the punch scrap container out of the machine, make sure to empty it 
completely. If it is reinstalled with some scraps remaining, it may become full before the 
message appears again, and this can cause machine breakdown.
Important • When emptying the punch scrap container, make sure that the machine is switched on. If not 
switched on, the machine will not recognize that the punch scrap container has been 
emptied.
• When the machine is in the Energy Saver mode, exit the Energy Saver mode by pressing 
the <Energy Saver> button and the <Machine Status> button on the control panel before 
you empty the punch scrap container.
• Before emptying the punch scrap container, press the <Machine Status> button and check 
the current status for the punch scrap container even when the control panel is lit.