Fuji Xerox ApeosPort-IV C5580, ApeosPort-IV C6680, ApeosPort-IV C7780, DocuCentre-IV C5580, DocuCentre-IV C6680, DocuCentre-IV C7780 Administrator Guide

Perpendicularity Adjustment

Perpendicularity Adjustment

16 Appendix
622
Ap
pe
ndix
16
Perpendicularity Adjustment
Adjust image skewing (squareness) in 0.1 mm increments for both sides 1 and 2.
Specify a positive value to adjust the position of the image in the opposite direction of 
the paper feed direction, and a negative value to adjust the image in the paper feed 
direction.
1
Check the sample printout, measuring the amount of squareness misalignment. 
Use the following equation to obtain the perpendicularity misalignment amount, with 
"A" as the length of the lead registration at the rear of the machine, and "B" as the 
length of the lead registration at the front of the machine.
Perpendicularity misalignment amount =(A - B) × 400 ÷ (length of Y direction of paper 
- 20 mm)
For example, when A3 is placed horizontally:
 (A - B) × 400 ÷ 277
2
Select [Perpendicularity], and then select 
[Change Settings].
3
Enter a value by adding the perpendicularity 
misalignment amount measured in step 1 to 
the current setting value of [Side 1] and [Side 
2].
Note
• The values displayed in [Side 1] and [Side 
2] vary depending on the machine. The 
Alignment Adjustment Type feature 
adjusts relative difference between the 
sides 1 and 2. Thus, if adjustable amount 
to the desired direction is not enough in one side, adjust the other side.