Fuji Xerox ApeosPort-IV C5580, ApeosPort-IV C6680, ApeosPort-IV C7780, DocuCentre-IV C5580, DocuCentre-IV C6680, DocuCentre-IV C7780 Administrator Guide

Stapler Faults

Stapler Faults

Stapler Faults
589
Pr
o
b
lem S
o
lving
15
Stapler Faults
This section describes how to clear stapler troubles when the optional finisher is 
installed.
Perform the procedures on the following pages when copies are not stapled or staples 
are bent. Contact our Customer Support Center if the problem persists after you have 
tried the following solutions.
If copies are stapled as shown in the figures below, contact our Customer Support 
Center.
Important • When using Finisher D2-P with Booklet Maker, depending on the type of paper that is being 
stapled, the stapled nails may be bent. If the bent nails are stuck inside the machine, they 
may eventually cause paper jams.
• Remove the bent staple when opening the staple cartridge cover. If you do not remove the 
bent staple, a staple jam may occur as a result. Use the staple cartridge cover only when 
removing the bent staple.
Unstapled
Bent staple
One side of staple rising up
Staple bent in reverse direction
Flattened staple
Entire staple rising up
Staple rising up with
center pressed in