Fuji Xerox ApeosPort-IV C5580, ApeosPort-IV C6680, ApeosPort-IV C7780, DocuCentre-IV C5580, DocuCentre-IV C6680, DocuCentre-IV C7780 Administrator Guide

Installation Procedures

Installation Procedures

Installation Procedures
349
Using IP
 F
a
x (SIP
)
10
Installation Procedures
This section describes the configuration procedures to use the IP Fax (SIP) feature on 
the machine.
The following shows the reference section for each procedure.
Step 1 Enabling Port and Setting up TCP/IP............................................................................ 349
Step 2 Configuring the SIP User Name ................................................................................... 350
Step 3 Configuring Fax Environment ...................................................................................... 350
Step 4 Configuring the SIP Server ........................................................................................... 351
Step 5 Registering the VoIP Gateway...................................................................................... 352
Step 1 Enabling Port and Setting up TCP/IP
To use the IP Fax (SIP) feature on the machine, enable the port and set the IP 
addresses. The following shows the configuration procedures on the machine.
You can configure the settings using CentreWare Internet Services. For information on how to use 
CentreWare Internet Services, refer to "Configuring Machine Settings Using CentreWare Internet 
Services" (P.297).
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator’s user ID with the numeric keypad or the keyboard 
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator’s 
passcode, and select [Enter].
Note
• The default user ID is "11111". 
• The default passcode is "x-admin".
3) Select [Tools] on the [Services Home] screen.
2
Enable the SIP port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [SIP], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
6) Select [Close] repeatedly until the [Tools] screen is displayed.
3
Set an IP address and the other addresses.
Skip this step if an IP address is already set.
If DHCP or BOOTP is available in your environment, configure the method for 
obtaining the address. If an IP address cannot be obtained automatically, or if manual 
configuration is preferred, confirm the settings of an IP address, a subnet mask, and a 
gateway address.
For information on how to set an IP address, refer to "Protocol Settings" (P.196).
4
Select [Close] repeatedly until the [Tools] screen is displayed.
5
Select [Close].