Fuji Xerox ApeosPort-IV C5580, ApeosPort-IV C6680, ApeosPort-IV C7780, DocuCentre-IV C5580, DocuCentre-IV C6680, DocuCentre-IV C7780 Administrator Guide

Configuration of Job Flow Sheets

Configuration of Job Flow Sheets

9 Scanner Environment Settings
342
Sc
an
n
e
r
 En
vir
o
n
m
en
t
 Se
t
t
in
g
s
9
Configuration of Job Flow Sheets
This section describes how to configure the machine to use the Job Flow Sheets 
service.
The following shows the reference section for each procedure.
Step 1 Enabling Ports and Setting up TCP/IP...........................................................................342
Step 2 Configuring the SNMP Port...........................................................................................343
Step 3 Configuration on the Computer .....................................................................................343
Step 1 Enabling Ports and Setting up TCP/IP
To use the Job Flow Sheets service, enable the SOAP, SNMP, and Internet Services 
(HTTP) ports, and set an IP address and other addresses. The following describes the 
configuration procedures on the machine.
Note
• You can configure the settings using CentreWare Internet Services. For information on how 
to use CentreWare Internet Services, refer to "CentreWare Internet Services Settings" 
(P.293).
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator’s user ID with the numeric keypad or the keyboard 
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator’s 
passcode, and select [Enter].
Note
• The default user ID is "11111". 
• The default passcode is "x-admin".
3) Select [Tools] on the [Services Home] screen.
2
Enable the SOAP port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [SOAP], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
6) Select [Close] repeatedly until the [Port Settings] screen is displayed.
3
Enable the SNMP port.
1) Select [SNMP], and then select [Change Settings].
2) Select [Port Status], and select [Change Settings].
3) Select [Enabled], and then select [Save].
4) Select [Close] repeatedly until the [Port Settings] screen is displayed.
5) Enable the Internet Services (HTTP) port as described above.
6) Select [Close] repeatedly until the [Tools] screen is displayed.
4
Set an IP address and the other addresses.
Skip this step if an IP address is already set.
If DHCP or BOOTP is available in your environment, configure the method for 
obtaining the addresses. If an IP address cannot be obtained automatically or manual