Fuji Xerox ApeosPort-IV C5580, ApeosPort-IV C6680, ApeosPort-IV C7780, DocuCentre-IV C5580, DocuCentre-IV C6680, DocuCentre-IV C7780 Administrator Guide

Step 2 Enabling Port and Setting up TCP IP

Step 2 Enabling Port and Setting up TCP IP

Configuration of Scan to PC
331
Sc
an
n
e
r
 En
vir
o
n
m
en
t
 Se
t
t
in
g
s
9
Step 2 Enabling Port and Setting up TCP/IP
To use Scan to PC service, enable the port (SMB or FTP client) and set the IP address. 
The following describes the configuration procedures on the machine.
Note
• You can configure the settings using CentreWare Internet Services. For information on how 
to use CentreWare Internet Services, refer to "Configuring Machine Settings Using 
CentreWare Internet Services" (P.297).
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator’s user ID with the numeric keypad or the keyboard 
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator’s 
passcode, and select [Enter].
Note
• The default user ID is "11111". 
• The default passcode is "x-admin".
3) Select [Tools] on the [Services Home] screen.
2
Enable the port.
Using SMB
Enable the SMB port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [SMB], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
6) Select [Close] repeatedly until the [Tools] screen is displayed.
Using FTP
Enable the FTP port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [FTP Client], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
6) Select [Close] repeatedly until the [Tools] screen is displayed.
3
Set the IP address of the machine and the other addresses.
Skip this step if an IP address is already set.
If DHCP or BOOTP is available in your environment, configure the method for 
obtaining the address. If an IP address cannot be obtained automatically or manual 
configuration is preferred, confirm the settings of an IP address, a subnet mask, and a 
gateway address.
For information on how to set an IP address, refer to "Protocol Settings" (P.196).
4
Select [Close] repeatedly until the [Tools] screen is displayed.
5
Select [Close].