Fuji Xerox ApeosPort-IV C5580, ApeosPort-IV C6680, ApeosPort-IV C7780, DocuCentre-IV C5580, DocuCentre-IV C6680, DocuCentre-IV C7780 Administrator Guide

Installation When Using Microsoft Network SMB

Installation When Using Microsoft Network SMB

Installation When Using Microsoft Network (SMB)
311
Pr
i
n
t
e
r
 En
vi
r
onm
en
t Se
tt
i
ngs
7
Installation When Using Microsoft Network (SMB)
This section describes how to install the machine using Microsoft Network (SMB).
The following shows the reference section for each procedure.
Step 1 Preparations................................................................................................................... 311
Step 2 Configuration on the Machine ...................................................................................... 311
Step 3 Configuration on the Computer .................................................................................... 312
CentreWare Internet Services Setting Items ............................................................................ 312
Step 1 Preparations
The following items are required to set up the machine to use Microsoft Network (SMB).
NetWare server
TCP/IP or NetBEUI network environment
The Driver CD Kit (provided with the machine)
Step 2 Configuration on the Machine
The following describes the configuration procedures to use Microsoft Network (SMB) 
on the machine. Enable the LPD Port, and then configure TCP/IP settings.
Note
• You can configure the settings using CentreWare Internet Services or the Driver CD Kit.
For the items that can be configured using CentreWare Internet Services, refer to "CentreWare Internet 
Services Setting Items" (P.310). For information on how to configure the setting using the Driver CD 
Kit, refer to the manual contained in the Driver CD Kit.
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator’s user ID with the numeric keypad or the keyboard 
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator’s 
passcode, and select [Enter].
Note
• The default user ID is "11111". 
• The default passcode is "x-admin".
3) Select [Tools].
2
Enable the SMB port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [SMB], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
6) Select [Close] repeatedly until the [Tools] screen is displayed.
3
Set an IP address and the other addresses.
Skip this step if an IP address is already set.
If DHCP or BOOTP is available in your environment, configure the method for