Fuji Xerox ApeosPort-IV C5580, ApeosPort-IV C6680, ApeosPort-IV C7780, DocuCentre-IV C5580, DocuCentre-IV C6680, DocuCentre-IV C7780 Administrator Guide

Protocol Settings

Protocol Settings

5 Tools
196
T
ools
5
Important • Using the default port number may cause the conflict with other ports. Confirm the setting 
that the port numbers assigned to the other ports are not used. 
Note
• You cannot select [Port Number], if HTTP port is disabled.
To configure [Port Number], enable port status and reboot the machine, and then configure 
[Port Number].
SOAP
Port Status
Select [Enabled] when you use an application program such as EasyOperator. 
Port Number
Enter a port number for SOAP from 1 to 65535.
The default value is 80.
Important • Using the default port number may cause the conflict with other ports. Confirm the setting 
that the port numbers assigned to the other ports are not used. 
WebDAV
Port Status
Select [Enabled] when you use an application program such as EasyOperator and Network 
Scanner Utility 3 to access folders in the machine.
Note
• You cannot select [Port Number] and [Operation Time-Out], if WebDAV port is disabled.
To configure [Port Number] and [Operation Time-Out], enable port status and reboot the 
machine, and then configure [Port Number] and [Operation Time-Out].
Port Number
Enter a port number for WebDAV from 1 to 65535.
The default value is 80.
Important • Using the default port number may cause the conflict with other ports. Confirm the setting 
that the port numbers assigned to the other ports are not used. 
Operation Time-Out
You can enter an operation time-out period between 1 and 65535 seconds in 1 second 
increments.
ThinPrint
Port Status
You can use the machine for print in the ThinPrint.print environment. The machine 
decompresses and prints the compressed print data sent from the print server.
Select [Enabled] when you use ThinPrint.
Port Number
Enter a port number for ThinPrint from 1 to 65535.
The default value is 4000.
Important • Do not use any numbers assigned to the other ports.
Note
• ThinPrint is available when the communication protocol uses IPv4.
• The maximum of three connections are possible at a time.
Protocol Settings
Set the parameters required for communications. In [Protocol Settings], you can set the 
following items.
Ethernet Rated Speed
Set the communication speed for the Ethernet interface.
Auto 
Select this to detect the Ethernet transmission rate automatically.