Epson Stylus Pro 10600 Setup Guide

Loading Roll Paper

Loading Roll Paper

7
6. Holding the ink cartridge with arrow mark on 
the left side and pointing to the rear of the 
printer, and insert it into the slot. Be sure to 
match the colors of the seal of compartment 
and the cartridge you are replacing.
7. Close the ink cartridge clamp backwards. 
Make sure the corresponding Ink Out light 
goes off. Repeat step 5 to 6 for the other five 
color ink cartridges.
8. Close the ink compartment cover.
After installing all six ink cartridges, the 
printer begins charging the ink delivery 
system and the Pause light flashes (for about 
7 minutes). When the ink delivery system is 
charged, the Pause light stops flashing.
c
Caution:
Never do the following while the Pause light 
is flashing; otherwise damage may occur:
Turn off the printer.
Open the front cover.
Open the ink compartment cover.
Move the paper lever to the released 
position.
Unplug the power cord.
Loading Roll Paper
Note:
The instruction here is for the 2-inch roll paper spindle 
(L). However, the procedure for 3-inch roll paper 
spindle (M) is the same.
1. Slide the movable flange off the end of the 
spindle.
2. Place the roll paper on a flat surface so that it 
unwinds in the direction shown. Slide the roll 
paper onto the spindle and fully onto the fixed 
flange.
3. Slide the movable flange back onto the spindle 
until it fixes into place in the end of the roll 
paper.
4. Open the roll paper cover. Holding the 
spindle, fit the right end of the spindle into the 
mounting bracket inside the printer.
Note:
The spindle and mounting brackets are 
color-coded. Mount the spindle into the 
mounting bracket that is the same color as the 
end of the spindle.
When you mount two roll paper spindles on 
your printer, mount the 3-inch type on the 
upper side brackets and the 2-inch type on the 
lower brackets.