Epson Stylus Pro 10600 Setup Guide

Installing the Ink Cartridges

Installing the Ink Cartridges

6
2. Attach the three clamps packed with your 
printer, then route the power cord through the 
clamps at the rear of the printer.
3. Check the label on the back of the printer to 
make sure the voltage required by the printer 
matches that of the electrical outlet you are 
using.
4. Plug the power cord into a properly grounded 
electrical outlet.
c
Caution:
Do not use an outlet that is controlled by an 
automatic timer or wall switch. Otherwise, 
accidental shut down or damage to your 
printer may occur.
Installing the Ink Cartridges
w
Warning:
The ink cartridges are self-contained units. 
Under ordinary use, ink will not leak from the 
cartridges. If ink does get on your hands, wash 
them thoroughly with soap and water. If ink gets 
into your eyes, flush them immediately with 
water.
1. Turn on the printer by pressing the Power 
button. After a short time NO INK CARTRIDGE 
is displayed on the LCD panel.
2. Push the ink compartment cover to open it.
3. Put the attached label for your ink type on the 
back of the ink compartment cover.
4. Push the top of the clamp, and pull it forward.
5. Remove the package from an ink cartridge.
Note:
If you use UltraChrome or ColorFast ink 
cartridges, shake the ink cartridge gently before 
installing it for best results.
c
Caution:
Do not shake cartridges that have been 
installed previously.