Epson Stylus Pro 10600 Setup Guide

Assembling the Stand

Assembling the Stand

2
For United Kingdom Users
Use of options
EPSON (UK) Limited shall not be liable against 
any damages or problems arising from the use of 
any options or consumable products other than 
those designated as Original EPSON Products or 
EPSON Approved Products by EPSON (UK) 
Limited.
Safety Information
w
Warning:
This appliance must be earthed. Refer to rating 
plate for voltage and check that the appliance 
voltage corresponds to the supply voltage.
Important:
The wires in the mains lead fitted to this appliance are 
coloured in accordance with the following code:
Green and yellow – Earth
Blue – Neutral
Brown – Live
If you have to fit a plug:
As the colours of the mains lead of this appliance 
may not match coloured markings used to 
identify the terminals in a plug, please proceed as 
follows:
The green and yellow wire must be connected to 
the terminal in the plug which is marked with the 
letter E or earth symbol (G).
The blue wire must be connected to the terminal 
in the plug marked with the letter N.
The brown wire must be connected to the terminal 
in the plug marked with the letter L.
If damage occurs to the plug, replace the cord set 
or consult a qualified electrician.
Replace fuses only with a fuse of the correct size 
and rating.
Warning, Cautions, and Notes
w
Warnings must be followed carefully to avoid 
bodily injury.
c
Cautions must be observed to avoid damage to 
your equipment.
Notes contain important information and useful tips 
on the operation of your printer.
Assembling the Stand
c
Caution:
Have two people working on either side to 
assemble the stand.
1. Hold base upright left (A) and a horizontal 
strut (C) as shown. Then fix the strut to the 
stand using the two hex socket head bolts (I) 
with the hex wrench (H).
Note:
An instruction sticker about the setting paper 
basket is attached to the side of horizontal strut.
2. Referring the step 1, fix the other strut to the 
base upright right (B).
This completes assembly of the stand. Before 
attaching the paper basket, mount the printer 
on the stand.
I